![]() When run on Linux / Mac OS X / BSD then some additional signals are supported to allow for additional control over the running daemon instance of sc_trans. Additionally the PID of sc_trans is listed in the log file. The PID of the daemon instance (reported when the daemon started or can be found with 'ps ax | grep sc_serv' as long as sc_serv was the file run otherwise you can just use 'ps ax' if the filename isn't known). 'sc_trans going daemon with PID ' where XXXX is the of the process. When run this should output the following: File path to the configuration file (required in all cases) ![]() Remember to enable the required access on the sc_trans file by doing 'chmod a+x sc_trans' after extracting it from the distribution file otherwise the OS is likely to not run it and show the error message './sc_trans: Permission denied'. File path to the configuration file (can be relative or absolute) To uninstall sc_serv assuming it was installed as detailed in the install section above then you would enter into the console: Name of service as used when the service was registered To run sc_serv with a configuration file in the same folder as the server as the current system user account you would enter into the console: When run as a service there is not a good sense of a current working directory so requires all paths in the configuration and playlist files to be fully qualified otherwise lookups will fail when sc_serv is run. If no file / an invalid file is specified then sc_trans will abort loading. Password for user or '0' for the local system or with no password User under which to run the service as or '0' for the local system To remember it as it is required to be the same when using the 'uninstall' mode. Typically enter this as 'sc_serv' though you can use a different name but you will need If sc_trans is unable to start due to a dependency issue then you will need to install the correct version of the package so it can run which depends on the version of sc_trans you are attempting to run: Please note that the Windows versions of sc_trans are built with a dependency against the Microsoft Visual C++ 2008 SP1 Redistributable Package. The Windows version of sc_trans is designed to run on fully updated and patched versions of Windows 2000, XP, Vista and Windows 7. Detailed below is how to get the transcoder running on the different operating systems supported by it. The transcoder is able to be run either as a console application or it can be run as service (Windows) or daemon (Linux / Mac OS X / BSD). The following sections will show how to get sc_trans up and running along with details on the configuration options it provides for handling different sources and outputs it can support. With a 'source' you can use then you will need to setup your configuration file for the transcoder so it can process the input source and provide an output which can be used by the DNAS server (see sc_serv2.txt in the sc_serv distribution for more details especially those for stream configurations as non-matching details will prevent sc_trans from being able to connect to it). To get started using sc_trans you need to have some media to play or to have a stream you want to relay via sc_trans. This document shows you the different configuration options supported by sc_trans along with basic and more advanced example configurations enabling you to get started with using sc_trans and the various features it can offer. This documentation remains here for legacy purposes only. The Shoutcast Transcoder (sc_trans) is no longer maintained or supported.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |